Transmission-qt Message "Error" at seeding

Ask for help and report issues with the Windows version of Transmission
Post Reply
Elektron
Posts: 2
Joined: Thu Aug 22, 2013 3:44 am

Transmission-qt Message "Error" at seeding

Post by Elektron »

Transmission-qt in the distribution displays the status of "error" in uploaded torrents, but actually gives. In the web interface, and transmission-gui everything is displayed correctly.
Can anyone met this problem?
Version 2.82 (14160)
Attachments
Transmission-qt_Error_Seeding.jpg
Transmission-qt_Error_Seeding.jpg (48.75 KiB) Viewed 4055 times
rb07
Posts: 1400
Joined: Sun Aug 24, 2008 3:14 am

Re: Transmission-qt Message "Error" at seeding

Post by rb07 »

Transmission-Qt for Windows doesn't get support here, its an unofficial port which gets supported at SourceForge (by me).

Open the log (View -> Message Log) and find any lines marked with the red dot. If there are, those are the real errors.

From the code I see that message displays when the torrent status is unknown (and there is no error), which should never happen... it means the code has an error, and its not in the Windows code. I'll see if I can find the problem.
rb07
Posts: 1400
Joined: Sun Aug 24, 2008 3:14 am

Re: Transmission-qt Message "Error" at seeding

Post by rb07 »

Is Transmission-Qt connected in a remote session to a very old transmission-daemon (version 2.33 or older)?

If the answer is yes, then that is the problem: Transmission-Qt doesn't support those older versions since version 2.40 (the communication protocol changed).
Elektron
Posts: 2
Joined: Thu Aug 22, 2013 3:44 am

Re: Transmission-qt Message "Error" at seeding

Post by Elektron »

My version was is 2.05, after update all is work
Thanx :P
Post Reply