Transmission says "Port is closed." Debug disagrees

[santa2000]

Using Transmission 2.84 on Mac OS 10.9.4

Transmission shows a red dot and states that port is closed even though debug log says port forward successful as show below.

I first turned automatic port forward off, and then turned it back on

2014-08-30 06:43:13 +0000 port-forwarding.c:180 [Info] Port Forwarding: Stopped
2014-08-30 06:43:13 +0000 upnp.c:266 [Info] Port Forwarding (UPnP): Stopping port forwarding through "http://192.168.0.1:80/WANIPConnection", service "urn:schemas-upnp-org:service:WANIPConnection:1"
2014-08-30 06:43:13 +0000 port-forwarding.c:92 [Info] Port Forwarding: State changed from "Forwarded" to "Starting"
2014-08-30 06:43:37 +0000 natpmp.c:70 [Info] Port Forwarding (NAT-PMP): initnatpmp succeeded (0)
2014-08-30 06:43:37 +0000 natpmp.c:70 [Info] Port Forwarding (NAT-PMP): sendpublicaddressrequest succeeded (2)
2014-08-30 06:43:37 +0000 upnp.c:223 [Info] Port Forwarding (UPnP): Found Internet Gateway Device "http://192.168.0.1:80/WANIPConnection"
2014-08-30 06:43:37 +0000 upnp.c:225 [Info] Port Forwarding (UPnP): Local Address is "192.168.0.6"
2014-08-30 06:43:37 +0000 upnp.c:300 [Info] Port Forwarding (UPnP): Port forwarding through "http://192.168.0.1:80/WANIPConnection", service "urn:schemas-upnp-org:service:WANIPConnection:1". (local address: 192.168.0.6:64919)
2014-08-30 06:43:37 +0000 upnp.c:303 [Info] Port Forwarding (UPnP): Port forwarding successful!
2014-08-30 06:43:37 +0000 port-forwarding.c:92 [Info] Port Forwarding: State changed from "Not forwarded" to "Forwarded"

So is my port closed or forwarded?

[santa2000]

UPDATE:

I doubled checked and my firewall DOES allows transmission to receive incoming connections.

canyouseeme.org reports:

Error: I could not see your service on xx.xx.xx.x on port (64919)
Reason: Connection timed out

64919 is the port that my transmission uses

[santa2000]

Problem solved.

I was under the impression that any device with uPnP will automatically port forward. But I had DMZ enabled in router setting, and so I still needed to manually forward a port.