User debugging help

Discussion of the Web Interface for Transmission, formerly known as Clutch. This applies to all version of Transmission
Post Reply
tim.dclinc@gmail.com
Posts: 1
Joined: Mon Jun 04, 2012 9:24 pm

User debugging help

Post by tim.dclinc@gmail.com »

I had been using transmission without issue for a while. I upgraded my firmware and module version, now it wont transmit. The web screen(s) open fine, but the transfer rate remains at 0%. Thinking it might be firewall issue (not sure why though since it was working before upload), i removed everything between the internet and my NAS except for a switch (no firewall capabilities), but still same issue.

Is there a way of viewing a log that might tell me whats going on? I have access to my NAS via SSH.

Transmission version is 2.12 (11412).

Thanks
Post Reply