Hi,
This is my my first post, and I have read the forum rules, so here goes:
* Transmission Remote GUI Version 4.1
* I installed it yesterday on nas4free
* No per-torrent or global bandwidth limits set
* My global and per-torrent peer limits are set to 60
* the `Peers' tab say there are 0 peers on most of the torrents, and up to 15 on others
* The`Trackers' tab shows an empty column
* Some of my torrents read "Finished", "Stopped", and finally one says "Downloading"
* On the torrent I am downloading, all peers have 100%. I have less than that.
* I have one tracker
* My incoming port is closed, but my router is using uPNP, and I have full D/L access so that isn't a problem
I have three problems:
1) Whenever I restart the nas4free, all the torrents are lost in Transmission Remote GUI. I then have to add them all again, verify them and start all over again everytime I reboot.
2) Whenever I add a torrent, it starts up fine, downloads for about 5 minutes, then stops. I have to manually restart it, and then 5 minutes later, it stops again.
3) Finally, when I go the site from where I am downloading, my user account only shows 8 of the about 45 torrents I am seeding!
Any suggestions would be appreciated.
All the best,
xbot64