Transmission-qt in the distribution displays the status of "error" in uploaded torrents, but actually gives. In the web interface, and transmission-gui everything is displayed correctly.
Can anyone met this problem?
Version 2.82 (14160)
Transmission-qt Message "Error" at seeding
Transmission-qt Message "Error" at seeding
- Attachments
-
- Transmission-qt_Error_Seeding.jpg (48.75 KiB) Viewed 4181 times
Re: Transmission-qt Message "Error" at seeding
Transmission-Qt for Windows doesn't get support here, its an unofficial port which gets supported at SourceForge (by me).
Open the log (View -> Message Log) and find any lines marked with the red dot. If there are, those are the real errors.
From the code I see that message displays when the torrent status is unknown (and there is no error), which should never happen... it means the code has an error, and its not in the Windows code. I'll see if I can find the problem.
Open the log (View -> Message Log) and find any lines marked with the red dot. If there are, those are the real errors.
From the code I see that message displays when the torrent status is unknown (and there is no error), which should never happen... it means the code has an error, and its not in the Windows code. I'll see if I can find the problem.
Re: Transmission-qt Message "Error" at seeding
Is Transmission-Qt connected in a remote session to a very old transmission-daemon (version 2.33 or older)?
If the answer is yes, then that is the problem: Transmission-Qt doesn't support those older versions since version 2.40 (the communication protocol changed).
If the answer is yes, then that is the problem: Transmission-Qt doesn't support those older versions since version 2.40 (the communication protocol changed).
Re: Transmission-qt Message "Error" at seeding
My version was is 2.05, after update all is work
Thanx
Thanx